The FlightClub Neutron custom drone frame has all the great features from the PROton, just shrunk down to use the smaller 20x20mm components.
Featuring a mini Nucleus plate that is CNC’d from a solid piece of aluminum. It has butter mounts and threaded holes for the arm screws. Butter mount is a flight controller mounting method invented by us that isolates the flight controller from any vibrations using custom silicone grommets. This greatly reduces noise in the gyro ensuring an ultra smooth flight. The mini Nucleus plate also has threaded holes for the arm screws that eliminates the need to fumble around with nuts to mount the arms. Simply screw the arm screws right into the aluminum plate.
The FlightClub Neutron with the Nucleus plate is designed for maximum flexibility. It has the ability to be built as skeleton mode (standoffs with a carbon fiber top plate) or hybrid pod.
5" Practice 22xx motor pattern (practice arms are slightly wider than the Race arms)
Flightclub neutron fpv race frameNeutron Highlights
5" arm configuration is 205mm
Mini Nucleus Plate CNC’d out of 7075 Aluminum
Can do skeleton or hybrid pod
Threaded holes in the Nucleus plate for easy arm replacements. No nuts or pliers needed.
Designed for 20x20mm components. (max length of board is about 36mm. No it will not fit the RF Spark32)
Butter Mounts for a vibration free flight controller stack. The Butter Mounts have a M3 center hole but M2 screws will work also.
Chamfered edges on the bottom carbon fiber plate
Countersunk holes on the bottom plate for a completely flat bottom
Camera protection on both skeleton and hybrid mode
Camera angle approximately: Hybrid pod 30-80, Skeleton 0-80 degrees
65g Skeleton (5? arms), 70g Hybrid Pod Canopy
This build is approximately 230g with 2205 motors without props or battery
EMAX Mini Magnum 2
Foxeer Arrow Pro Micro
Lumenier AXii Stubby
Base Neutron will include the following
1 – Mini Nucleus CNC Aluminum Plate
1 – 2.5mm chamfered, countersunk bottom CF Plate
4 – 4.5mm Arms
12 – Silicone injection molded Butter Mounts
4 – M3x20mm Button head screws (for flight controller stack)
9 – M3x10mm Flat Head Hex screws (arm screws)
4 – M3 Nylon nuts
1- TPU VTX antenna mount
1 – FlightClub Velcro Strap
1 – FlightClub Sticky Battery Pad
TPU Printed Hybrid Pod will include the Base Neutron above plus:
2 – M3x10mm standoffs
2 – M3x25mm standoffs
8 – M3x8mm button head hex screws
Different height Standoffs can be used for higher or lower stacks.
A 20x20mm VTX carbon fiber plate is available separately.