TrampHV revision 2.0 is “the” standard for competition racers, it is fully developed for drone racing. It is the smallest and lightest module with a maximum output power of 600mW and 6S supported.
The traditional ImmersionRC 5V filtered camera power supply is also included for noise free clean video feed.
If you combine the Tramp HV with the TNR Wand it supports Pit mode. This enables the possibility to work, test and change frequencies on your quad during races or when flying with friends without interfering with each other. During pit mode, the transmission power is reduced to less than 1 mW.
Race directors can define the frequency and power output of the transmitter, in 5 seconds flat before a race starts without powering up a model.
The frequencies and power output can also be set manually
The TrampHV constantly monitors the temperature of the Tx, and gracefully reduces power output to increase battery life and protect the transmitter. As soon as the props start spinning, it detects the temperature reduction and
quickly boosts power output.
Smallest direct LiPo powered vTx in the business.
TNR Wand Touch-free control
Traditional button+LED control of frequency and power
1mW -> 600mW linear power control
All 40 standard channels
Built-in thermal protection
Factory power normalization
Glitch-Free frequency changes
Micro-power pit mode
Additional channels for race events (Race Wand only)
Dimensions: 32mm x 14mm x 5mm.
Weight: 4g Tx only.
Power Output: Programmable, 1mW to > 600mW.
Channels: 48 standard, arbitrary using race wand.
RF Connector: U.FL.
AV Connector: JST-GH, 6 pin, locking.
TNR Connector: JST-GH, 4 pin, locking.
Audio: Mono, Subcarriers on 6.0 and 6.5MHz.
Power Requirements: 2s-6s HV Lipo.
Power Consumption: 4W max @ 600mW.
TNR Touch-free wand control.
Traditional button+LED control of frequency and power.
All 48 standard and raceband channels.
Built-in thermal protection.
Additional channels for race events (Race Wand only).
Download the TrampHV Manual
Products details from ImmersionRC